Reviewing Mould Assembly and Mounting Faces before Installation

An assembly review should connect the completed mould with the mounting arrangement on the receiving machine. HAWEN's quality information covers assembly and machine interface considerations. The relevant review scope needs to be agreed for the supplied tooling rather than assumed from the appearance of a completed assembly.

Use the Correct Installation References

Identify the mounting and locating surfaces, connection points and orientation shown on the approved drawings. Confirm which parts belong to the supplied assembly and which are retained on the machine. Where an existing arrangement has changed, those changes should be included in the reference information.

Before installation, request clarification of discrepancies in the drawings, component identification or supplied scope. Photographs can support a review of visible condition and orientation, but they cannot establish every fit or operating requirement. Questions about alignment, fastening and movement should be resolved using the applicable instructions and project information.

Assembly Review Checklist

• Match the mould identification and revision to the agreed documents.
• Identify the mounting faces, locating features and installation orientation.
• List supplied parts, retained parts and any unresolved interface questions.
• Agree the required inspection records and responsibilities for installation review.

Installation and machine operation should follow the equipment supplier's instructions and the plant's safety procedures. Do not use a general article as a fastening or adjustment specification. Share the machine and mould references with HAWEN so the discussion can address the actual assembly and the information needed before installation proceeds.