bauma CHINA 2024 Review of a KVM Paver Mould Project

Project review · bauma CHINA 2024

From an Exhibition Discussion to a Mould Project

HAWEN's published Russia project report identifies bauma CHINA 2024 in Shanghai as the starting point of this cooperation. The customer subsequently visited the Quanzhou mould workshop before selecting HAWEN.

The Follow-up Recorded by HAWEN

The report describes two interlocking paver mould sets for a KVM machine, with a 1400 × 1100 mm pallet size, shipped to Russia in early May 2025. The photographs on this page document the resulting mould project. They should not be read as new photographs of the 2024 exhibition.

Making an Exhibition Meeting Useful

Bring a product drawing and identify the machine on which the mould will run. After the meeting, keep the geometry, interface information and agreed design requirements together for review. An exhibition discussion starts the enquiry; the final mould specification depends on the individual production setup.

See the paver mould range and contact us with the details of your proposed project.

A Practical Follow-up Checklist

• Identify the finished product, machine model and the person responsible for the drawing review.
• Record which dimensions and interfaces are confirmed and which need further information.
• Keep the revised drawing and questions together so a later technical discussion can address the same version.

Source: HAWEN Machinery original report.